Hi all, the hub on my JTD is knackered, there is a JTS being broken not too far from me and I was wondering if they'll fit? I now the carrier is the same but if the driveshaft splines are the same?
Boxy
Driveshaft splines are the same, but the ABS sensor plugs are not necessarily the same, compare them both before purchasing. As a rule, ABS sensors will break if you attempt to remove them so I usually sell 2nd hand hubs complete with the sensor attached.
Pud, I've read a lot of problem posts on here over the years and you seem to pop up a lot with the solution!
I had a feeling this was the case but just wanted confirmation so thanks, I'm not too fussed if I goose the sensor on the replacement hub as I was lucky enough to tease the sensor out on my own hub a couple of times already and always stuck a bit of copperslip on. I know its plastic but it seems to work
I had a feeling this was the case but just wanted confirmation so thanks, I'm not too fussed if I goose the sensor on the replacement hub as I was lucky enough to tease the sensor out on my own hub a couple of times already and always stuck a bit of copperslip on. I know its plastic but it seems to work
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
