Alfa Romeo Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
Hello,
I notice that the two big black plastic mouldings on either side of the engine have the screws missing. They just lift off.
Any ideas where I can get hold of the correct ones. Don't have a dealer near me though.
Thanks.
 

·
Registered
'98 GTV V6
Joined
·
1,299 Posts

·
Registered
Joined
·
4,627 Posts
First, check the plastic inserts are still in place in the receiving bodywork. The screws may not be there because they've gone!

If the plastic inserts are missing, search eBay for 'lokut' ( measure the size of the holes to get the right size ).

I used stainless steel screws and washers. Details in this thread - http://www.alfaowner.com/Forum/alfa-gtv-andamp-916-spider/941185-under-bonnet-guard-screws.html

Note the washer size in my initial post is wrong. The correct size is noted later in the thread.

The fixing near the strut mounting is a M6 bolt with pozidriv head.
 
1 - 4 of 4 Posts
Top