Alfa Romeo Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi I have just put a new engine in my 147 2.0L TS. I have put the wiring loom in apart from one electrical connection. I started wiring on top of the engine and worked my way round to the back. I wired up the starter and across to the alternator and that’s where I find myself with a wire and can’t see where to plug it into. It’s a single wire/single plug connection.
I have attached a couple of pics. Any ideas?
147 a.jpg

147b.jpg
 
L

·
Guest
Joined
·
0 Posts
either oil pressure sensor, located on the rear of the block near the alternator
 
L

·
Guest
Joined
·
0 Posts
OR air con pump, if you don't have air-con just bundle it up under the engine cover
 

·
Registered
Joined
·
9 Posts
Discussion Starter #5
Thanks guys i found the oil pressure switch and wire is now attached. I just couldnt see it from where i was lying under the car.
Hopefully have her rebuilt tomorrow. Fingers crossed.
Thanks again
 

·
Registered
Joined
·
9 Posts
Discussion Starter #6
SHE'S ALIVE!!!!!!!!!!!!!!!!!!!!!!!
1 year since i blew her engine up and she breaths again.
Been rebuilding her for 3 months in a stoney, dusty damp car park in the limited spare time i have.
I did get a few funny looks as i did a victory dance around the car park in my boiler suit. lol
 
1 - 8 of 8 Posts
Top