Wheel bearing

554 Views 2 Replies 1 Participant Last post by wrinx, Oct 11, 2003

G

Discussion Starter · #1 · Oct 11, 2003

Bit of a swine to get off but it is off, however its left part of the ball race behind.

Stuffing me face with pizza at the moment so time to get a few ideas before I have another crack............any ideas?

wrinx

1 - 3 of 3 Posts

speedy

· Registered

Joined Jan 1, 2003

·

4,651 Posts

#2 · Oct 11, 2003

Wrinxy you`ll need a vice to hold it and a BIG hammer and a chisel

Make sure you keep the chisel on the old race or you`ll damage the shaft

G

Guest

·

Discussion Starter · #3 · Oct 11, 2003

Would you believe it came off no problems!!! I presumed it would be nearly welded to the shaft as the bearinf was a sod to get off

All sorted now

wrinx

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.