WANTED. Detailer in SW London

1 - 1 of 1 Posts

bellaitalia

Registered

Joined Mar 23, 2007

163 Posts

Discussion Starter • #1 • Jun 1, 2016

my 156 GTA needs a proper clean and I simply do not have the tools, skills and time! Is there anyone near Putney (or is willing to travel to me) to give the beauty a thorough going over? Have researched but can't find anyone close. Thanks

1 - 1 of 1 Posts

Recommended Reading

Bird crap hassle

Car Detailing

Hiya, just cleaned off a load of bird crap of the most sinister kind. It was welded to the bodywork and gave me all the trouble I needed when clean8ng it off. Even after that there is still flat spots on the paint where the most stubborn bits were. Any ideas on what I can do to restore the...
- 8
- 248
- Phase3dude · updated 3 d ago
August 2020 Detailing Competition Entries

Car Detailing

Please include some info on what you have done to your car. Don't forget to check out the updated rules Monthly Detailing Competition Rules Voting now open for the previous entries July 2020 AO Detailing Competition Vote
- 2
- 117
- David P · updated 6 d ago
Washing regime

Car Detailing

As per other thread just washed the car for first* time in over 6 months... i use a karcher pressure washer to wet it, then snow foam thickly with autoglym polar blast, leave for 20 mins today, rinse with washer, then use a small fat boa with the detailers touch up shampoo, then rinse again...
- 17
- 270
- tpmmpt · updated 6 d ago
Autoglym polar blast, any good

Car Detailing

Afternoon I like the look of the Autoglym polar blast system, but is it any good?? and could i use a normal polish as well, say every three months or is it good enough on its own??? Any feedback would be appreciated, ta bob
- 15
- 151
- S
  Stugman · updated 8 d ago
Advice on wheel protection and cleaning

Car Detailing

Afternoon My new Giulia has diamond cut alloys I have searched for tests on alloy wheel sealers and brushes and almost every test has different results, so can i grab some pointers as to a good sealer and brush??? Ideally easy to apply, read that AG is not recommended for diamond cut alloys...
- 3
- 142
- S
  Stugman · updated 8 d ago