Alfa Romeo Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
The turbo is a T 03 from a Fiat Coupe turbo 16v,the same as the one on a Q4 I presume?I am going to have it fitted on my homemade manifold,and then I have to turn the house in the middle of the compressor and the turbine(so the oil-output will be straight down).No problem on the compressor side,but the turbine side is teesing me.First the 6 bolts:-I had to use gas & oxygen on them before I could loosen them.Now they are all loose,but the turbine house is VERY stuck,and I won't use violence(unless it's the right way to do it wink ).

Anybody who knows what to do??
 
G

·
Discussion Starter · #2 ·
if you have all the bolts out then you will need to give it a smack they become very tight and rust themselves on be carefull to make sure it comes off straight you dont want to bend any blades.
 
G

·
Discussion Starter · #3 ·
Thanks jb,I will try that,but yesterday I went to next project who is making new excust from turbo to cat(or where the cat should be wink ).When this is done,I will follow you'r tip. :)
 
1 - 3 of 3 Posts
Top