I have just bought a pack with two parking sensors very cheap and was wondering if anyone has fitted sensors to a 147 rear bumper. Not sure about a safe place to drill holes(i.e. nothing behind) Thanks
i've got some fitted to mine in 4 locations, i sprayed them recently to colour match the car - i think the best advice would be to remove the rear bumper to fit them - there's four bolts along the top which are holding it in place,you can access by opening the boot, I was also advised there may be a couple of screws holding it in that you can access via the rear wheel arches, though not so sure if there are any there.
Hello. I need help. The barometric sensor shows over 1200 mBar. ECU Reset shows 1013 mBar and increases while driving. Is this normale? Is the barometric sensor in the ECU damaged? Other sensors replaced with new ones.
Will a 147 undertray fit 3.2 GT? I have seen a few advertised on ebay that look very similar to the remains of my current undertray and considerably cheaper than aluminium one. I may try and fabricate my own aluminium one at a later date.
One I am looking at is as follows...
You need the model number and serial number...
Only for 147,156 and GT factory fitted Blaupunkt radios.. POST 2001.
Then enter your serial number ... starting BP
code eg BP037822578162
One of our friendly helpers will be along with a code for you shortly :)
Since I've owned my 147, every now and then there would be a clattery rattling from the exhaust. This would occur on cold start up, then usually disappear as the exhaust heated up. Uninvestigated diagnosis (speculation) was a slightly loose pre-cat (i.e. the internal core matrix). Since the...
Just an idea.:)
To have a thread where we can share what we have done or bought or considered for our beloved cars "today" thread.
Hopefully this might catch on?
I will kick off..
Managed to align my front bumper properly...Big thanks to shiny car's guide to bumper removal. Once i had...