Alfa Romeo Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter #1
Can anyone give some advice. I have just fitted some replacement front seats to my 156.

Now when I had only the driver seat in I had to move the car with out the passenger seat in place.
I have now fitted the passenger seat and the red airbag light stays on.

Before removing and fitting these seats the airbag light was not on.

Have I bought seats with a faulty airbag or is the issue there because I turned the ignition on when one of the seat was removed.

Can I clear by disconnecting the battery.

Any advice much appreciated.

Thanks.


Wayne
 

·
Registered
Joined
·
6,274 Posts
Unplugging any of the airbag components without disconnecting the battery for ~1/2 an hour will cause a fault to be registered.

It needs to be reset. You can do it with AlfaDiag, or take it to a dealer
 

·
Registered
Joined
·
12,881 Posts
AlfaDiag Alfa Romeo Diagnostic Software ... you'll also need a modified KKL cable, you can either buy one from ebay for about £8 and get your soldering iron out ... or rarebear (on here) can sell you a pre-modded one (for quite a lot more than £8)
 
1 - 4 of 4 Posts
Top