Alfa Romeo Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter #1
This messsage flshed up on dash this evening, car still runs 100% fine. Now I presume this is for the swirl flap motor?? If it is I blanked flaps a few months back and just left the motor in situ, so can I completely remove fault through diagnostics?? Or is there a way I can do it through wiring/ resistors?? Or is the fault something else??
 

·
Registered
Joined
·
143 Posts
Could be any number of things you need to read the codes to find out what has caused it - motor control failure is a generic message telling you that a monitored function is not working or out of limits
 

·
Registered
Joined
·
1,144 Posts
Yep mine was fit egr valve, ended up cleaning
Egr
Map
Maf

And only then after a bit of driving did the light go out.

Start with a 1.6ohm resistor
 

·
Registered
Joined
·
154 Posts
Sounds like the crankshaft sensor. If it stops without obvious reason and restarts after a while then looks like it. The message seems to disappear and only the light remains on in some instances.:vomit:
 
1 - 4 of 4 Posts
Top