I have used numerous window cleanets in the past but was given Nanolex Glass Cleaner as a Christmas present and used it today. Impressed with t although it smells like Windowlene. i use either a cheap kitchenr roll to apply and a microfibre to polish off although today I used compressed cotton wool pads to apply and the microfibre to polish off. Apparently the Nanolex has some anti fog prperties as part of its make up so this could help with your issue perhaps.
My preferred stuff is Autoglym Glass Cleaner. Spray, dry with clean kitchen roll and polish with a microfibre cloth.
Really easy and will help with condensation.
Look at the colour of the kitchen roll and that will show you how dirty the glass was !
I could get slaughtered here but ah well, it works for me.
Interior glass has always been a pain, cleans up ok only to go smeary in time, tried all sorts of cleaners and clothes but always the same.
I have some bottles of Williams waterless wash for the outside that I only ever use if its my only option, I used it on the rear screen of the Spider once and was expecting it to smear up in time but it didnt, some time later I tried it on the door glass and same thing, smear free so thought lets give it a go on the windscreen and rear screen and ever since the glass has stayed absolutely clear.
It shouldnt work, putting a canuba based wash/wax on glass doesnt sound good but it works or at least has done for several months (6 months +) now.
Perhaps I should add that I never wipe the inside if it is steamed up or covered in condensation and always clear it through the fan, this probably helps stop the smearing.
I use a product called Stoner Invisible Glass and lots of blue paper towel, the fairly expensive thick stuff.
I've never had any success with microfiber towels or any other type of cloth. I think the key with interior glass is to use a decent cleaner with no ammonia, and something absorbent that you change often.
I used a vax steam cleaner on some very dirty glass a few years ago which loosened it up nicely.
Hiya, just cleaned off a load of bird crap of the most sinister kind. It was welded to the bodywork and gave me all the trouble I needed when clean8ng it off. Even after that there is still flat spots on the paint where the most stubborn bits were. Any ideas on what I can do to restore the...
Please include some info on what you have done to your car.
Don't forget to check out the updated rules Monthly Detailing Competition Rules
Voting now open for the previous entries July 2020 AO Detailing Competition Vote
As per other thread just washed the car for first* time in over 6 months...
i use a karcher pressure washer to wet it, then snow foam thickly with autoglym polar blast, leave for 20 mins today, rinse with washer, then use a small fat boa with the detailers touch up shampoo, then rinse again...
I like the look of the Autoglym polar blast system, but is it any good?? and could i use a normal polish as well, say every three months or is it good enough on its own???
Any feedback would be appreciated, ta bob
My new Giulia has diamond cut alloys
I have searched for tests on alloy wheel sealers and brushes and almost every test has different results, so can i grab some pointers as to a good sealer and brush???
Ideally easy to apply, read that AG is not recommended for diamond cut alloys...