Alfa Romeo Forum banner

hub nut

642 Views 4 Replies 4 Participants Last post by  Pomeo
what size is the nut holding the drive shaft to the hub?
1 - 1 of 5 Posts
forget but do a search - its all been done before. Normally you need to get angle grinder on the outside of socket to thin it enough to fit inside the hub flange.
And a big piece of scaffold tube or a good impact driver.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.