Alfa Romeo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I´m installing a 116 TS gearbox into my 75 V6. But my TS gearbox misses the clutch fork pivot ball (I think that´s the name of the little thing that controls the clutch fork?).



The space around the "head" of the pivot ball is very limited. What tool may work? As the picture shows i´ve tried heating up a simple wrench, but it became either too soft or too porous.

Any tips?

regards,

Carl Larsson
 

·
Registered
Joined
·
355 Posts
I used a pair of 'vice grips' a small set with longer thin nose. They just fitted thorugh the hole to both undo and retighten the pivot ball (after the ball had broken off..)
 
1 - 2 of 2 Posts
Top