[jayjay73]

Hi - may be a bit of a long shot - I want to replace the fasteners which hold the headlight unit in place on the innermost side (see photo) for stainless ones as they are rusted badly. I am guessing they are M6 x 16mm (as I needed a 10mm socket to remove them - thread seems to be either 5 or 6mm but I don't have a micrometer to double check). Is the thread pitch standard? If I buy Stainless M6 x 16mm Hex Flange Bolts will they fit?
If anyone knows for sure what they are that would be cool.
Thanks
Jay

 

[sensingsys]

These are what I used http://www.ebay.co.uk/itm/M6-A2-STAINLESS-STEEL-HEXAGONAL-FLANGE-BOLTS-DIN6921-6mm-THREAD-FLANGED-/200826099517?var=500104778120, I think I went for the shorter 12mm length bolts as I thought the originals were over long. As I remember it, there were also the same bolt used to secure the headlights under the black trim panels and also to secure the windscreen washer reservoir, all of which were rusty, so getting 4 or 8 bolts would be sensible.

 

[jayjay73]

Cheers thanks for this. :thumbup: