Alfa Romeo Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
Hi all

I have a problem with loss of power on acceleration at the mo which seems to happen later on in the revs and I have MAF unplugged as trying to eliminate possible causes. It does seem slightly better with it unplugged but still hesitation especially when changing up through the gears. Anyway I am going to change the plugs and see if that changes anything before I buy an OBD lead. I have looked at previous posts about socket sizes but would just like to clarify, is it 10mm or 14mm that I need and what sort of length extension bar? Also do I need to depressurize fuel system before I take the inlet plenum off (think that is the name).
Please excuse my lack of knowledge, I am on a learning curve with this beauty as not had her long :)

Thanks for your help, it is much appreciated

Ken
 

·
Registered
Joined
·
30,082 Posts
10mm & 14mm refer to thread sizes, not socket sizes, but they are a 14mm thread.
They are a 16mm (5/8") hex.
 

·
Registered
Joined
·
20 Posts
Discussion Starter #4
Thanks for your comments.

I will check the air intake hose too as renewing air filter next week.

Cheers
 
1 - 4 of 4 Posts
Top