[Corp_J]

So here's my dilemma, Cobalt on here is selling a custom GTA exhaust backbox. I was just wondering if this will fit on a standard 147 without to much effort.

Does anyone know if all the mountingbrackets, pipe bends etc are in the same place as a GTA?

 

[Pud237]

The chassis is the same, so it will fit underneath fine, brackets are all in the same place. The tailpipe position is different (to fit the GTA bumper cut-out) and the length will be a little shorter as the GTA has longer mid cats. Its also bigger bore. I'm sure its possible with a little work.

 

[OperationAlfa]

No point in fitting it to a diesel though!

 

[Corp_J]

Nice one, that's all I needed to know.

Its purely aesthetic. Also I need a small box on the back as the standard will be getting dangerously low to the ground when I lower the car.

 

[OperationAlfa]

But due to the larger bore you will lose back pressure.. Might slow you down.

 

[Corp_J]

That's a good point. I hadn't considered that