[iceman288]

Could someone tell me the correct size torx bit require for removal of GT front bumper pls I think mine must be worn and I don't want to knacker the heads up .many thnx
Mark

 

[Aramis]

T30

 

[halftone]

Whilst on this subject, do any of the usual sources sell these large, flat headed Torx bolts?

 

[pubsinger]

You can pick them up on eBay, not a bad deal that!

Also available from a dealer, part number #46419734 or #51810310 but according to ePer they'll only sell them in packs of 20.

I've replaced all mine with black M6 bolts and penny washers.

All the best

Pub

 

[edraven71]

If you want to go posh try probolt https://www.pro-bolt.com/aluminium/aluminium-bolts-and-washers-countersunk.html

Use the countersunk with the washer got all anodized ones in red to match my paintwork for the front and rear bumpers, plus lots of other's for low load fixings around the engine bay. and they won't rust and look much nicer than the standard ones.

Be warned though you will start looking for anything you can swap and end up spending way more than you wanted to:biglaugh:

 

[halftone]

I know Probolt ;-)

The eBay versions seem to lack the collar/short plain shank, which will crush the plastic. Same with penny washers, although they're what I've used for the undertray now I've replaced the knackered rivnuts. I just have one snapped-off Torx, irritatingly front centre...