Alfa Romeo Forum banner
1 - 12 of 12 Posts

· Registered
Joined
·
4 Posts
gt switches are differnt from 147 ones due to the frameless doors so will not be interchangable,
as far as i know, the lower part denotes what car they are from

lower part is either black, grey or greeen, i cant remember off hand but im sure its grey is 3dr 147, black is 5dr 147 and green is gt.
 

· Registered
Joined
·
71 Posts
However if it is just the plastic switch part that is broken you can swap the 147 switch onto the gt electrics (just clips on) just make sure you don't loose the little grey pegs inside. I did this with a 147 switch and it works perfect. Added bonus is that the ecu won't throw any errors either :)
 

· Registered
Joined
·
2,830 Posts
Discussion Starter · #6 ·
However if it is just the plastic switch part that is broken you can swap the 147 switch onto the gt electrics (just clips on) just make sure you don't loose the little grey pegs inside. I did this with a 147 switch and it works perfect. Added bonus is that the ecu won't throw any errors either :)
Yes!That's all i need.The top part only.
That's it then!
Thanks to all.:thumbs:
 

· Administrator
Alfa 159 1.9 JTDm Sportwagon
Joined
·
6,287 Posts
The passenger switch unit is just a switch, the driver side is the control module and is programmed diiferant for the GT. The top of the switch module can be used for the parts.
 

· Registered
Joined
·
4 Posts
I have problem now with my driver side switch and I can get only black switch from 147 not from GT, can I buy this switch and put on driver side and do laptop adding new switch procedure or with 147 switch I will loose soft close and car will never be a same one?
 

· Administrator
Alfa 159 1.9 JTDm Sportwagon
Joined
·
6,287 Posts
The switch lever, the thing which you push-pull is the same GT /147 usually the tabs brake off the switch lever.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top