Alfa Romeo Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter #1
drivers side front indicator is full of condensation so am going to drill a hole in it to remove some moisture...how do you remove it from bumper?
Has anyone had this prob and how was it remedied?
thanks
peter
 

·
Registered
Joined
·
4,646 Posts
you have to remove the bumper

5 Torx30s bottom
4 torx 30 at top, unde rthe 2 small grilsl which are helding by 4 + head screws + tnhe centre parts by 2 + screws.

then remove both wheels & 2 + screws form wheel arch

then remove 5 more Torx 30 screws....

bumper will come off

then 2 10mm nuts & apop out clip will remove the headlight.
 

·
Registered
Joined
·
111 Posts
Discussion Starter #3
Jeepers...just to check its the indicator not headlight, just in case you misread my post as your response mentions headlight.
Thanks
peter
 
1 - 3 of 3 Posts
Top