Alfa Romeo Forum banner
Cancel
Create thread New Garage Forums

Error code help needed P1062

Jump to Latest
4.5K views 6 replies 4 participants last post by  Ed_  
E
#1 ·
I've got P1062 coming up, using Veepeak OBDII reader and Torque Pro app, which I bought from a recommendation from this board. Only thing is, P1062 is an unknown code on Torque and I can't find anything exact from googling. The vehicle message is "Start/Stop is unavailable. Check engine" (I didn't know I had start/stop!) It's a 2012 Giulietta 1.4 multiair. Anyone any ideas?
Cheers
Ed
 
W
#5 ·
I believe jetronic77 means the solenoid coils in the MA not the ignition coils. Compare the resistance for cyl 2 against one of the others. The doc below lists all the troubleshooting steps for that code.
 

Attachments

Save
Reply Quote Like Like
#6 · (Edited)
May I suggest to try cleaning the connections to the MA solenoids first, if that fails then try replacing/cleaning the MultiAir Oil Strainer. These suggestions may or may not solve your problem and you may be up for a replacement MA unit, but should be done before going any further.
 
Alfa Romeo Forum
posts
7.3M
members
228K
Since
2001
The friendly Alfa Romeo Club - If you are looking to buy or you are already an Alfa Romeo owner, join alfaowner.com today to get the most from your ownership
Full Forum Listing
Explore Our Forums
Alfa 147, 156 & GT Alfa 159, Brera & Spider General Alfa Discussion Alfa GTV & 916 Spider Introduce Yourself