Alfa Romeo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter #1
So Following a few other issue i decided to clean my MAP sensor (2.0 jtdm 170)

This turned out to be a good move as it was completely blocked with crap. BUT, while carefully removing the senor (apparently not carefully enough) I snapped the clip on the back/bottom of the sensor that holds it in place along with the bolt.

Is this going to be problem eg. boost leak. If yes is it a new manifold?

Thanks
 

·
Registered
Joined
·
12,570 Posts
They're usually a tight fit, can you fashion some tie wraps to hold it in place?
 
1 - 2 of 2 Posts
Top