Alfa Romeo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi there! Can anybody forward me the torque settings for an Alfa 156 v6 24v cylinder head?
 

·
Registered
Joined
·
1,305 Posts
24nm, then 26nm, than 240° is the proper method. I didn't have the angular tool so I marked one corner of each nut, then I counted 4 corners and made a corresponding mark on the head (6 sides = 360°, therefore each side = 60° therfore 4 sides = 240°).

I've read a v6 expert say you can do each nut in 20nm increments up to 88nm, but my wrench only goes up to 60, so I'm sticking to the official method. Dont forget to clean and oil the nuts, washers and threads.
 
1 - 2 of 2 Posts
Top