Alfa Romeo Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
4,482 Posts
Discussion Starter #1
I'm hoping to fit a new ribbed belt crank pulley (TVD) to my 2.0JTDm this weekend...I say hopefully as I was supposed to have the part last Tuesday via a 24 hour courier ....several stroppy emails later and I still don't have it! Anyway....assuming it comes does anybody know the correct torque of the four bolts that hold it in position and if any thread lock is required. Thanks in advance.
 

·
Registered
Joined
·
669 Posts
25nm is the usual for such bolts.
 

·
Registered
Joined
·
4,482 Posts
Discussion Starter #3
Thanks....I did find the actual figures in the end. 24nm + 29nm.
 

·
Registered
Joined
·
669 Posts
No, not 24nm + 29nm, it is between 24 & 29 nm.
 

·
Registered
Joined
·
4,482 Posts
Discussion Starter #5
My CD manual days torque to 24 first then 29....either way it's done now!
 

·
Registered
Joined
·
2,964 Posts
I shouldn't have thought an additional 4nm would be an issue - but elearn states between figs - with this symbol (±)
 

·
Registered
Joined
·
4,482 Posts
Discussion Starter #7
It's not an additional anything really....I've just set it at the upper limit.
 

·
Registered
Joined
·
2,964 Posts
Granted, I could have worded that better... :rofl:
 
1 - 8 of 8 Posts
Top