Alfa Romeo Forum banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
...they may appear more substantial than previous Alfa
'visors, but they really are rubbish quality.

The elbow metal tube section is just held in by a tiny
bit of plastic that will obviously just break off.
As mine has done.


How annoying. :rolleyes: :rolleyes: :rolleyes:
 

·
Registered
Joined
·
297 Posts
As they said....
....you need to move to a cloudier climate....:cool::cheese:
 

·
Registered
Brera 3,2 JTS Q4, Lacia Thesis 3,2
Joined
·
41 Posts
Old thread, but I think that someone still suffer about this. I made a fix for my Brera's sunvisor problem: I had small part 3D-printed and fixed according to photos attached. Now the visor stays on, and you can even turn it easily. I cut the plastic with hacksaw blade, and finished with sharp knife. Glue was epoxy, and so far I am happy with it. Only time will show, how strong the fix is.





Unfortunately forgot to take the pic with new part glued on place, but it is there.
I had 20 parts printed, so I still have 19 left, if someone needs such a repair.
 
1 - 5 of 5 Posts
Top