Alfa Romeo Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
I require a boot badge for my 2004 Alfa Romeo 156 2.4 JTD Multijet - I have ssen geuine badges that seem to fit into two small hole on the boot but I have also read that they are affixed with a 10 mm bolt?
 

·
Premium Member
Joined
·
2,042 Posts

·
Registered
Joined
·
1,309 Posts
Not sure on your badge but im sure you can peel the badge of the plastic which i have done and got a metal one from the seller below , the quality is top notch.

You need to choose a badge then message him to say you want just one and he will set up a listing for you to buy etc . cant beat the price ive got all my badges from them and they are metal.

If you mention your responding to a forum recommendation you should get a good price like a couple of quid

Dont forget to measure the badges you want to replace

Good luck

http://stores.ebay.co.uk/topcarhouse?_trksid=p2047675.l2563
 

·
Registered
Joined
·
222 Posts
As far as I can tell it come down to age of the car. I think that up to 2000 they used the bolt and after it was just the prongs. Does your badge move so you can get at the key hole?
 

·
Registered
Joined
·
17 Posts
Discussion Starter #5
Thank you for your prompt reply - the badge does not move as the boot is opened either by the key or a lever near the drivers seat.
 
1 - 6 of 6 Posts
Top