[Imoan2]

I had the C-Tek Comfort Panel fitted at the dealer before I picked the car up and it was connected to the 10mm nut on the negative battery post.

I reinforced the battery door with fibreglass matt and fitted it in the door along with a fuse panel so I could have the auxilary power outlets.

 

[Imoan2]

I bought this

13.12US $ 21% OFF|19pcs 6 Way Auto Blade Fuse Box Holder Block Panel 32v Car Power For Auto Car Marine - Fuses - AliExpress

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com

and used sticky back velcro to attach it to the top of the battery.
Then wired to the + & - terminals

I can take a picture during the week if you need it.

 

[Imoan2]

I have to be honest I was surprised there wasn't one as standard.
I too carry a cold/hot box and as a lot of things now have USB charger cables that's why I fitted that also.
I'll take a couple of pics tomorrow.

 

[Imoan2]

Here you go

 

[Imoan2]

I have a CTEK charger and use the ones under the bonnet

I used mine for the first time last night, I set it to AGM but now I'm unsure if it is an AGM battery?
I cycled the mode button so the AGM light was illuminated but after about three hours the regular battery light was illuminated also.
The battery status never got past stage five?
Oh! and I have the C-Tek comfort panel that is connected directly to the battery.

Any illumination 😀 I would be grateful for.

 

[Imoan2]

you should NOT

Ooops!
Thanks for that much appreciated