Alfa Romeo Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
Hi All,

I'm on the hunt for the front bumper plastic insert below the foglight (N/S, passenger)

Any suggestions?
 

·
Registered
Joined
·
658 Posts
I'm thinking I've seen these advertised possibly on FB, someone was 3d printing them. You are referring to the V6 bumper with oil cooler?
 

·
Registered
Joined
·
21 Posts
Discussion Starter #3
Yes there's two on either side, my passenger one is missing...

do you have a link?

thank you
 

·
Registered
Joined
·
658 Posts
Only use FB for research and occasional market place purchase, so don't get myself too involved with it.
However searching for 3d Printed Alfa Romeo grills found the post.

I'll not put his name on an open forum.

This is the group
Alfa Romeo GTV/Spider 916 Technical Forum
 

·
Registered
Joined
·
97 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #8
thanks for the link, yes already seen this advertised on ebay… too pricey plus I only need one.
 

·
Registered
Joined
·
1,705 Posts
The originals are also very expensive if you can find them - I paid that much for a s/h pair. On the driver side it is a metal mesh (to allow air flow to the oil cooler) in a plastic frame, on the passenger side it is a plastic blanking plate. Those 3D prints look like a mesh pattern for both sides.
 
1 - 10 of 10 Posts
Top