Alfa GT - Custom Chrome Grill
1 - 8 of 8 Posts
Joined
·
786 Posts
This is special carwash floor based intecooler...
For excuse... I give one better view on bumper...
I had opposite intention, because IMO chrome grill is a corresponding part of bumper on high class sport sedan...
In comparison with this, boy-racer car has many more decorative non-performance parts...
Attachments
Joined
·
2,913 Posts
1 - 8 of 8 Posts
Join the discussion
Recommended Reading
-
Bird crap hassle
Car DetailingHiya, just cleaned off a load of bird crap of the most sinister kind. It was welded to the bodywork and gave me all the trouble I needed when clean8ng it off. Even after that there is still flat spots on the paint where the most stubborn bits were. Any ideas on what I can do to restore the...- 8
- 276
-
Phase3dude · updated
-
August 2020 Detailing Competition Entries
Car DetailingPlease include some info on what you have done to your car. Don't forget to check out the updated rules Monthly Detailing Competition Rules Voting now open for the previous entries July 2020 AO Detailing Competition Vote- 2
- 146
-
David P · updated
-
Washing regime
Car DetailingAs per other thread just washed the car for first* time in over 6 months... i use a karcher pressure washer to wet it, then snow foam thickly with autoglym polar blast, leave for 20 mins today, rinse with washer, then use a small fat boa with the detailers touch up shampoo, then rinse again...- 17
- 291
-
tpmmpt · updated
-
Autoglym polar blast, any good
Car DetailingAfternoon I like the look of the Autoglym polar blast system, but is it any good?? and could i use a normal polish as well, say every three months or is it good enough on its own??? Any feedback would be appreciated, ta bob- 15
- 175
-
Advice on wheel protection and cleaning
Car DetailingAfternoon My new Giulia has diamond cut alloys I have searched for tests on alloy wheel sealers and brushes and almost every test has different results, so can i grab some pointers as to a good sealer and brush??? Ideally easy to apply, read that AG is not recommended for diamond cut alloys...- 3
- 159
Join now to ask and comment!