Alfa Romeo Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
959 Posts
Discussion Starter #1
Looking for a set of 1.7 16v heads to put on my 8v block.
Apparently i will also need a 16v sump n crossmember.
Thinking about it i will probably need the pulleys as well or can i use 8v pulleys, as i have a few verniers.

If anyone can help, i would appreciate it.
 
K

·
Guest
Joined
·
0 Posts
i don't have a 16v crossmember, but need an 8v one for my sud, are the 33s the same as suds :rolleyes: :cool:
 

·
Registered
Joined
·
1,465 Posts
Kev - If its for the Ti you need one with the anti-roll bar mounts. Some (all?) 8V 33,s didnt have an anti-rollbar. Sure you could fabricate it if needs be though.

rsfruitbat.
 

·
Registered
Joined
·
1,465 Posts
Alex your best bet is definately a complete car as you will probably need fuel tank aswell if staying with injection. At least if you swap parts you could have an 8V car to sell afterwards?


rsfruitbat
 
K

·
Guest
Joined
·
0 Posts
ok all, will have a better look at mine once it's out, but i can already spot a couple of places that will need repairing, will send it to be shotblasted once it's off..................sometime next year :lol:
 
1 - 6 of 6 Posts
Top