Alfa Romeo Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
Hi all,
Yesterday i changed the front section of my exhaust(Manifold to just before the cat).The previous one cracked in half where the mesh is.Anyways when i woke up yesterday to take it to the garage.The car was acting funny,revving so low under 0.5 rpm the car felt like its was going to cut out(which actually did a few times)and also when i tried to drive it the car didn't want to move,no power.I thought this was due to the pressure of the exhaust etc.So i gave it a lot of revs in neutral just to free it up and the car seemed fine after tha(drove ok,no jerkiness).When i taken it to the garage it cost me £70 parts + labour and started the car and drove it home fine around 3pm.When i then got back into the car at 9.30pm same problem,car was reving so low the headlight was goming dimmer and brighter and it revved to the point of cut off.th car was undrivable as it kept stalling.Just want any advice on what this could be. By the way the lanbda was put back tightly. :confused:
 
1 - 1 of 1 Posts
Top