Alfa Romeo Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Need to replace the rocker cover as it is cracked on my 2007 GT 2.0JTS could someone tell me the torque setting and tightening sequence? Cant find it anywhere
 

·
Registered
Joined
·
3,021 Posts
Unless someone knows different, I just start in the centre and work outwards in much the same way as doing a cylinder head. I've never torqued one either but M6 screws would be no more than possibly 8Nm due to the type of gasket.
 

·
Vendor
Joined
·
46,276 Posts
If you need a rocker cover I think I have a good used one. The torque setting is very low, can't remember off the top of my head but I'm sure its single figures.
 
1 - 4 of 4 Posts
Top