Alfa Romeo Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hello, everyone this car was towed to my shop with the transmission inoperative. I pulled the unit(ZF4HP18Q) and rebuilt it.The pump drive gear had split. After reinstalling I find the unit in failsafe mode and there is no voltage at the electrical connector at the trans. I just can't find any info on this car from conventional sources and I'm hoping you can tell me where the fuse that must protect this circuit is located and which pin in the connector should have 12V. Thank you in advance for your assistance.
 

·
Registered
Joined
·
867 Posts
Hi there & Welcome! :p
 
1 - 9 of 9 Posts
Top