Alfa Romeo Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
129 Posts
Discussion Starter · #1 ·
About to get my GTA wheels refurbed and the guys doing it have offered to powdercoat my front 330 calipers for next to nothing.

Downside is that I must completely strip them myself... so I want to replace the O-rings, piston boots, etc etc. Might also replace the pistons themselves.

Anyone have some part numbers / sources? I've seen some kits for other Brembo calipers that include new piping, screws etc etc. That would be very nice.

Many thanks.
 

· Registered
Joined
·
129 Posts
Discussion Starter · #7 ·
Cheers Chris. I've got the Big Redd seals etc in my possession now. I can see you were brave enough to split the calipers. I've been advised not to as the bolts often snap, leaving you with a steel stud in an ally body (ie buggered). Any thoughts? I do have center punches / easy outs etc, but not sure if it's worth the risk.

Thanks again
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top