Hello all - first post after 18 months of lurking and living with my '54 Plate 2.4 JTDm SW - not bad!
I have searched plenty on this, but can't find anything 100% conclusive - I would normally just go and measure up too, but the wife's out in the car!
The top hose, currently patched with Gaffa tape, has started blowing again - does anyone know the diameter of the hose clips needed for both top and bottom Turbo hoses?
I'm just going to get some self-amalgamating tape and new clips from Amazon (one's spinning) to patch it up until I can figure out a cost-effective silicone alternative...
Is it 50-70mm?
Trivial question I know, but thanks in advance none the less!
I have searched plenty on this, but can't find anything 100% conclusive - I would normally just go and measure up too, but the wife's out in the car!
The top hose, currently patched with Gaffa tape, has started blowing again - does anyone know the diameter of the hose clips needed for both top and bottom Turbo hoses?
I'm just going to get some self-amalgamating tape and new clips from Amazon (one's spinning) to patch it up until I can figure out a cost-effective silicone alternative...
Is it 50-70mm?
Trivial question I know, but thanks in advance none the less!
