Alfa Romeo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
722 Posts
Discussion Starter #1
Just about to reassemble my 2.0 JTS motor having had the head skimmed.

This being my first JTS, I bought a set of JTS cam locks along with the head gasket set and various other bits and pieces from Alfa Workshop.

However - there are no instructions with the locks as to which cam lobes they fit over.

eLearn says inlet cylinder 3 and exhaust cylinder 2; but these locks look identical to my TS cam locks which go on inlet cylinder 2 and exhaust cylinder 3. I didn't bother locking the cams when I disassembled because I knew I was going to strip the cams from the head...

The part number is correct for the JTS motor.

Can anyone advise?
 

·
Registered
Joined
·
727 Posts
You are correct, eLearn in this case is wrong.
 
  • Like
Reactions: Pud237
1 - 2 of 2 Posts
Top