Alfa Romeo Forum banner
1 - 3 of 3 Posts

· Registered
115 Posts
Discussion Starter · #1 ·
Guys I really need need some help as I can't work this out. I need to add resistors for my LED stop and indicator bulbs but I just can't stop the Canbus errors.

As far as I can tell the colours are and as follows:
Black = Ground
Grey = Brake
Yellow / Black = Tail
Blue / Black = Indicator

I've attached both resistors to the Black then connected one resistor to the grey and the other resistor the blue black. Sadly this doesn't work. (See in the attached pic)
The passenger side works fine but the ground is in the opposite place.

Any ideas, as I'm at a loss :(


1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.