Alfa Romeo Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
237 Posts
Discussion Starter #1 (Edited)
Hello on this scorching Sunday afternoon.

Just had the above off the car and refurbished and about to reinstall. Has anyone got access to eLearn and can check the bolt torque requirements for me please?

TIA


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
592 Posts
keeping it simple

all M10 bolts 56 - 68 Nm
all M8 bolts 22 - 27 Nm other than
prop shaft - rear drive idler casing side 31 - 37Nm

hope that helps

cant copy and paste as elearn is on my other pc along with MES
 

·
Registered
Joined
·
237 Posts
Discussion Starter #3
keeping it simple

all M10 bolts 56 - 68 Nm
all M8 bolts 22 - 27 Nm other than
prop shaft - rear drive idler casing side 31 - 37Nm

hope that helps

cant copy and paste as elearn is on my other pc along with MES


Simon you’re a gent! This is perfect...just what I need thank you so much.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
2,510 Posts
Boom, boom!


Sent from my iPhone using Tapatalk


Hi Stevie, I was reading an old thread about wheel alignment settings for the Q4, and you seem to be very happy with the way you had yours set-up.
Could you shoot me some settings please

Kind regards

Clay....


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
237 Posts
Discussion Starter #7
Hi Stevie, I was reading an old thread about wheel alignment settings for the Q4, and you seem to be very happy with the way you had yours set-up.
Could you shoot me some settings please

Kind regards

Clay....


Sent from my iPhone using Tapatalk


Hi Clay...yes that was a long time ago and was actually my old 159 Ti saloon, which was a fwd 1.9 Jtdm. The Q4 is a recent purchase for the missus.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
2,510 Posts
Hi Clay...yes that was a long time ago and was actually my old 159 Ti saloon, which was a fwd 1.9 Jtdm. The Q4 is a recent purchase for the missus.


Sent from my iPhone using Tapatalk


I see. Hope it’s not to much trouble (the Q4).
Was the prop-shaft faulty?


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
237 Posts
Discussion Starter #9
Centre bearings gone, a common issue with the Q4.Had it remanufactured by North West Propshafts and the bearings are now serviceable so futureproofed at a fraction of the truly exorbitant cost of a new replacement from the dealer.


Sent from my iPhone using Tapatalk
 
1 - 9 of 9 Posts
Top