Alfa Romeo Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,059 Posts
Discussion Starter #1
Hi I always feel the seat I got with 156GTA is higher than my previous 156 2.0 T.S. (standard leather). I found my T.S. seat was perfect height position. But the 156GTA is bit too high even with lowest setting. I'm just wondering is there anyway to lower it abit. But I presume it has the electrical recline that has loads of wiring underneath might not be possible.:(
 
A

·
Guest
Joined
·
0 Posts
Very strange, I had a 156 2.0 JTS with the TI seats, and then in the GTA I found that I am sitting a bit lower than in my old 2.0 JTS. But then again both seats are quite hard, not soft like the normal 156 seats. So this could be the reason, the GTA seat is harder even though I am quite sure it is lower than the normal seat(I did spend some time in the regular 156 leather seats as well).
 

·
Registered
Joined
·
8,063 Posts
My 1999 156 has lower leather Momo seats than my 2001 156 with leather seats. Both are Momo design and look almost the same except the later ones dont have Momo embossed on the seat and have perforated seat bases.

Later ones also have more lateral support and taller rear head rests.
 
1 - 3 of 3 Posts
Top