Alfa Romeo Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
I'm two weeks into my first Alfa ownership, and I realise thart I need to replace the inner gaiters on both driveshafts.
I'm fairly handy with the tools, but is this a DIY job or garage job.
Advice on who or how to do will be appreciated.
 

·
Vendor
Joined
·
46,115 Posts
I think the driveshafts have to come out for this.. Are you up to that?

You will need to replace the gearbox oil seals if you disturb the driveshafts. I didn't replace the gearbox oil seals when the clutch was done on my JTD and it all needed to come apart a week later as I noticed it was leaking oil :rolleyes: :mad:

As you are getting quite involved with the suspension it would also be a good time to replace top or bottom wishbone arms if the bushes or balljoints are screwed. Getting a Q2 limited slip differential in would only be another hour or so of work as well..
 
1 - 3 of 3 Posts
Top