Alfa Romeo Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
have a 156 2.4 jtd the car is lowered and is wearing the inside of the tyres can i adjust the camber caster or is this fixed
 

·
Registered
Joined
·
8,063 Posts
Unfortunately its fixed but normally the front tyres wear on the inside because the tracking is not set correctly. If you set the front alignment to parallel then this will vastly reduce the tyre wear
 
G

·
I have the same problem and i have my tracking at 0.00 and I still have very bad wearing on the inside.I was told to get the camber changed.Is it fixed on the GT too?
 

·
Registered
Joined
·
8,063 Posts
I have Eibach Pro springs on my 156 V6 and so its pretty low..........no uneven wearing of the tyres :)

I have just less than -2deg of camber on the front
 

·
Registered
Joined
·
30,252 Posts

·
Registered
Joined
·
30,252 Posts
Any ideas what I can do so?:confused:
Are you sure the front toe is set to zero?
Are you running the correct tyre pressures?
 

·
Registered
Joined
·
30,252 Posts
Yeah,had the tracking done with new tyres and set it at 0.00,pressure is 32 as per recommended.
32psi is too low.
If you have 18" you need 36psi front, 35psi rear.
 

·
Registered
Joined
·
30,252 Posts
32 is still too low!!
 
1 - 13 of 13 Posts
Top