Alfa Romeo Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #4
Thanks for all your help guys, where is the best place to get V6 hubs from? are the calipers in the listing good value?
 

·
Registered
Joined
·
30,067 Posts
+1 and you need new alloys or use 15mm hubcentric spacers
Well depends on the wheels he has, mine only had 6mm spacing to clear the brembo. :)

@Steve, post pics of your car so we can see what wheels it has. :)

And the brakes seem OK, but a tad pricey IMHO, I got my pair for 70 quid and my last pair for not much more. :)

I got my V6 hubs off ebay.
 

·
Vendor
Joined
·
45,772 Posts
Thanks for all your help guys, where is the best place to get V6 hubs from? are the calipers in the listing good value?
V6 hubs don't fit TS shocks, so you would need V6 shocks as well. Also, I'm pretty sure the splined end of a TS driveshaft doesn't engage with a V6 hub properly, so maybe you would have to press new TS bearings into the V6 hub carriers.. Its a lot of faffing about IMO.
 

·
Registered
Joined
·
57 Posts
Discussion Starter #8
Here are my wheels, there aftermarket 8x18's, not sure of the offset though. There is plenty of space between the TS calipers and the wheel though



Sounds like its turning into a bigger job than i thought, I know it might sound stupid but i was looking at fitting them mainly for the looks!
 
1 - 9 of 9 Posts
Top