Alfa Romeo Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,277 Posts
Discussion Starter #1
When I bought my 147 the OE radio didn't sit right and rattled like crazy. When had a look see I found that the plastic stud that screws onto the metal bolt sticking out from the back of the radio was broken.

When I looked on EPER I found out that the stud wasn't available as a seperate part.

I sourced a used one but that wasn't long enough and appeared to be missing a rubber cap of some kind. I then tried a stud from a 156 which also doesn't fit.

Can anyone please help??? Pictures of the right stud and where it fits into in the depths of the dash would be super helpful. If anyone has a spare one lying around I'll PAY for it and have it fetched from your home or work.
 

·
AO Silver Member, 155 Lounge Winner 09
Joined
·
7,713 Posts
You should be able to DIY with a bolt and a piece of rubber hose or similar. You might have bits and pieces in the garage to use?!

There is a recess in the black plastic heater/ventilation unit where it pushes 'into'. Not deep at all, but enough to support the back of the radio.

:)
 
1 - 2 of 2 Posts
Top