Alfa Romeo Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,412 Posts
Discussion Starter · #1 ·
I am looking to upgrade the single piston front brakes on my car to the Brembo set up, I know I will need the uprights as well as the calipers from either a ti or 2.4 but will the uprights from a Brera 3.2 4wd also fit or are the drive shafts different and also will I also need to change the master cylinder.

Also, is there a bracket available to mount the radial mounted smaller 4 pot calipers onto my uprights and with 305mm discs
 

· Registered
Joined
·
3,412 Posts
Discussion Starter · #3 ·
Hi, from what I understand the later 1.9's apart from the ti had 305mm discs with smaller brembos, the 3.2, 2.4 and 1.9ti had the larger 330mm set up.

If there is a bracket to fit the smaller radial 4 pots to my smaller discs then I'll do that but if I have to change the uprights then I might as well go for the bigger set up but there seems to be more 3.2 Brera's being broken but I want to make sure the front upright and hub will fit before I buy them, I dont want to go messing about with changing driveshafts etc
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top