Alfa Romeo Forum banner
upright
1-10 of 10 Results
  1. Alfa 147, 156 & GT
    A simple enough job: replace upper and lower wishbones and driveshaft (the LH one with intermediate bearing. I did the other side a couple of years ago, and expected it to take 3hrs. 2 days so far....It all went OK until I found I could not separate the upright from the upper wishbone balljoint...
  2. Alfa 147, 156 & GT
    For ages now there have been some niggling problems with the GTA which need addressing. Spurred on by fellow Alfisti activities during lockdown the GTA is receiving some love, first on the list are the crusty uprights. Hopefully this thread can help those are are similarly sprucing up their...
  3. Alfa 164 & 166
    Center front armrest stuck in upright position and won't return to the horizental one. Pressing the release knob has no effect Any ideas? Pre facelift 166. Tnx Shai
  4. Alfa 147, 156 & GT
    Hi, I've got a pair of 156 GTA upright and a set of 4-pot brembo from a Fiat Coupe 20V Turbo, and a pair of new 305mm discs. I want to fit these to my existing 2.0TS 156. I've also got a set of 17" GTA rims for the fitment. I know the wheel bearing for 2.0TS needs to be swapped to the GTA...
  5. Alfa 147, 156 & GT
    of I'm not getting the right support from the right side of the upright part of the drivers seat can I just swap the back of the seat with the back of the passenger seat. I know I have seat height adjustment in the base so I was hoping I could just swap the backs. it could just be in my head...
  6. Alfa GTV & 916 Spider
    Hi, I didn't think my first post would be about this issue. I have a 2000 916 spider 2.0TS. I have a replacement wheel upright with wheel bearing included (as I had a wheel bearing issue) for the O/S/R. Rather than try and press the bearing out, I was offered a upright wheel with bearing in...
  7. Alfa GTV & 916 Spider
    Not a major thing but bit of a niggle I want to put right. The electric roof works fine on my 916 Spider. But as the hood cover comes down and settles into place, that upright flap of colour coded trim, that sits behind your seat, that is meant to fold down and catch under the cover to complete...
  8. Alfa 147, 156 & GT
    when changing my springs i noticed that the gap between the inner side of the tyre and the upright part of the suspension that attaches to the upper wishbone is only around 5mm which to me is a bit small. none gt wheels came with the car not sure which alfa they're off so im guessing the offset...
  9. Alfa 33, Sud & Sprint
    I couldn't think of how best to describe so find below a picture :) Looking for the flat ones from series 1/2 car to match what you see in the pic, they are to go on our white racer :D
  10. Alfa 147, 156 & GT
    Howdo! I've got meself a set of GTA uprights and calipers, alocal garage are gonna press out the bearing & hubs then fit new bearings and my GT hubs. Is a special socket required to remove the centre retaining nut?? Best jacking up point? Any thing esle I should know?? Any info most...
1-10 of 10 Results
Top