Alfa Romeo Forum banner
throttlebody
1-12 of 12 Results
  1. Alfa GTV & 916 Spider
    Hi Alfaowner First off sorry for my bad English :D But any way, i have a Alfa spider 3.2 2005 With the famous Clicking Throttlebody and not starting(and no contact with ecu). starts when the throttlebody is off. Have checked All fuses All relays All ground cables Throttlebody All wiring...
  2. Alfa MiTo
    Recently bought a Mito 1.4tb 135 multiair distinctive. Have an ongoing intermittent problem where the engine management light comes on and it disables a lot of features like start/stop and usually will be in limp mode till i turn it on and off again. The car has been to 2 different mechanics...
  3. Alfa GTV & 916 Spider
    Just a quick rundown of my Porsche Cayenne Throttlebody install. The TB is ID 78mm as compared to 72mm original and a lot cheaper than F360 (76mm) or F430 TB´s (80mm) that is the usual choice. I bought a second han one of Ebay for 50£. First of I did not really know what to expect and reports...
  4. Alfa 147, 156 & GT
    Could somebody tell me the diameter of an original 156 GTA throttlebody (I cant find it on the internet). I've ordered a custom air intake and I got one with a 80mm hole but it was too big, when I measured the throttlebody it was 76mm... The parts store claims that the original body was 80mm and...
  5. Alfa GTA
    Does anyone have a F430 84mm TB for sale? Is it the same as the Masser 4200?
  6. Alfa 164 & 166
    Hi y'all Just thought I would share a little "unfortunate" experience. Yesterday evening whilst trying to get the N/S HID bulb out I noticed a split in the angled breather pipe from the throttle body flexi hose. (2.5 V6) Perhaps when I put the hose back after wrapping the relevant section in...
  7. Engines (TS, JTS, JTD & V6)
    Hi Guys, Little bit of advice require if possible... I have a '99 156 V6 which is a bit temperamental of late. I've recently changed the MAF and Lambda for OEM parts and also the battery (and done the obligatory throttle/ecu proceedure afterwards). While I was at it i thought i'd clean the...
  8. Alfa GTA
    Like the title sais, does anyone know the outer diameters of the GTA throttle body and MAF ? I am too lazy to check myself, and I want to fully rebuild the intake using silicone parts.
  9. Alfa GTA
    So, Driving home tonight found the car to feel very gutless in the midrange under load so lifted the bonnet once home to find this. I'm going on the EVO Triangle run at the weekend and need to get this sorted ASAP so was wondering about my options and would like to know if it would be safe to...
  10. Alfa 147, 156 & GT
    Hi All Wondering if anyone can assist? Own a 2004 V6 CF3 Engine with motorised throttle. When engine is warm I am experiencing MCSF warning and the car is put into Limp Home Mode. Usually restarting and keeping revs up whilst driving away will takes the car out of Limp Home Mode...
  11. Alfa 147, 156 & GT
    I wonder if anyone has advice on cleaning throttlebody on my 156 2.0ts. I rave read of various problems in doing this. Also I might try the ignition reset through ignition sequence, again any thoughts?? This is all as a last chance fix for my surging idle fault. All thoughts welcomed. Ta
  12. Alfa GTA
    Since both Selcuk and I are planning to do the Ferrari 360 Throttlebody upgrade to our 3.2's we are opening a thread (hopefully a writeup) on the subject. - Selcuk, hope you don't mind me starting out here...:) First I'll start out by uploading some photos of the spare GTA plenum i have. The...
1-12 of 12 Results
Top