Search Results for ‘support’

Evening all, dont suppose anyone is selling or knows anyone breaking a 5 door 147? I'm after the rear parcel shelf support trim that the parcel shelf sits on? I need both sides, I'll attach a picture of what I mean Cheers Sent from my SM-G973F using Tapatalk

Radiator lower support bracket on my 166 v6 is badly corroded and I can't find a new or decent secondhand one. Noticed in another post GazzaF15her talked about making one!!

i will sell a 164 rear axle subframe support. i bought it in good condition 2 years ago, then sand blasted and hot zinc dipped. 280eur plus shipment. located in germany, so shipment to overseas might be too expensive. (my 164 is dead, timing belt):bigmouth: greets, hans

Hello all!!! A quick question.. I need to remove the gearbox from 1970 1750 GTV. A friend has mentioned that I'll need to support the rear of the engine, however, the 2 workshop manuals I have don't mention anything about supporting the engine. Can anyone confirm please? Thanks in advance! Dan

Anyone tried to change the right engine support (p/n 51813198)? Is it an easy task or do the engine need to be supported from below during the exchange? Any recommendation for the new part? There are two different part numbers (50515482 and 51813198) so I assume there must be a different in...

There are plates either side that support the front subframe that bolt to the floor of our '96 Spider. The bushes are buggered. Any ideas on how to find replacements?

Looking for help on a 1982 GTV6 2.5 (116 Model).

As per title. Can you use wing supports from GT’s and 147’s on a 156 or are the totally different. Need a pair for my sw as the bottoms are rotted out.

I'm really loving my 166, what a seriously under-rated car. But one thing which is spoiling it a bit for me is a sore back! I'm 99% convinced it's because of the lack of lumbar support on the seat as it's bang-on that particular spot. Apart from this lower "clutch-side" LHS back I can get proper...

It's odd that both lumbar supports have stopped working at the same time. It seems, but not definate, to coincide with the battery being disconnected. There seems to be power to them both as there is a clicking sound coming from the back of the seats when the switch is pressed. Is there some...

Hi all Maybe of some interest to some of you - Alfa Romeo 156/155/146/145 Front Wing Brace Repair Section Gazza

Hi all Maybe of some interest to some of you - Alfa Romeo 156/155/146/145 Front Wing Brace Repair Section Gazza

Hi all Maybe of some interest to some of you - Alfa Romeo 156/155/146/145 Front Wing Brace Repair Section Gazza

Over on JeepOwner.com a jeeper has been quoted a case STAR number for his issue. That means they are using SAP CRM sofftware. :lol: If that's FCA wide then there's the problem right there !!! Ditch that and levels of service will rise accordingly! :D

Dear all, I have a GTV V6 TB phase 2 '98 with a problem on gearbox; 5th and reverse are very dificult to engage but later run with any problem. I check visually that all linkages (by cables) show OK and I decided to buy a new gearbox (i should to check also hydraulics :ermm:). I know that GTV...

Just recently my workshop which specializes in Alfas mounted set of Eibach ARBs. They however encountered some problems after mounting front stabilizer. Eibach front stabilizer 10-20-320-VA is more bended in the middle than the standard GTA/GT 3.2 V6 one, that is why it takes more place in the...

I read that Android Auto will be available on new Alfa Romeo's soon: https://www.android.com/intl/en_uk/auto/alfa-romeo/ Is there any possibility this can be backported to existing Gulia models? Also what about Apple Carplay support? Finally is Microsoft planning a Windows Phone equivalent...

I visited my local Alfa dealer to buy an Alfa Red touch up paint. While there I asked about their experiences with the software updates. The touch up whilst listed on the system "wasn't available to order". The service reception checked with the Alfa technician and reported that as he'd not...

This is part of the ongoing saga of my wife's 04 147 1.9JTD 16v and it's failed cambelt. After having spent £400 on the broken cambelt kit and then having it fitted, on turning the engine by hand, metallic noises come from within. These weren't apparent before the kit being fitted. We (after...

Phone button support with Connects2 SWC!!!! Hi There! Please help me, I just bought and installed a Connects2 UNI-SWC.2 steering wheel control in my Alfa 159 with Pioneer Avic-f10bt HU. Everything's working fine except the phone button. I can't answer or reject calls. This adapter known this...