Alfa Romeo Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 24 Results
  1. Alfa 164 & 166
    Dear friends, This is a RHD model and I removed the instrument binnacle to fix some non operating warning lights. I had this problem with air distribution. Air comes mostly from top vents to windscreen and a bit towards front. This is a problem because cold air makes windscreen condense from...
  2. Alfa GTV & 916 Spider
    As can be seen in this thread, I have contacted Ignition Car Parts and they are very keen to remake the idle stepper motor. It is the unit with Alfa Romeo p/n 71713829 and Bosch...
  3. Alfa GTV & 916 Spider
    As title, know they are rare as F.C. uk-working that is. Took mine apart tonight to see what could be wrong, put it back together so not hopeful it's sorted. So, anyone have a spare working one for sale? J
  4. Alfa GTV & 916 Spider
    Hi, I am after an idle stepper motor - part nr. 0132008650 for by GTV 2.0 TS phase 2 variant. They seem to be quite difficult to trace. Thanks Edward
  5. Alfa 147, 156 & GT
    What started as a simple job on changing the sidelights turned out to be a replacement job of the starter and control unit... Seems somewhere in the past they closed the headlight without refitting the rubber seal. Starter was corroded and full of water. Replaced it with a new one and at least...
  6. Alfa GTV & 916 Spider
    One of mine is kaput, for the headlamp levelling. Anyone know a good online source for a replacement? Thanks
  7. Alfa GTV & 916 Spider
    Hi, My Alfa GTV 1999, 2ltr twin spark keeps cutting off whilst driving. Mangoletsi have said they do not have the examiner and interface to reprogram the stepper motor and to fix the fault any more. Does anybody know where I can take my car to have it fixed. My mechanic says its definitely...
  8. Alfa 147, 156 & GT
    Hi guys I have a 2004 147, right hand drive, and am trying to find the stepper motor that controls the climate/heater temperature. Has anyone any ideas where it might be? I've pulled half the dash off but can't find it. I can see the cam for the air-directon stepper motor - that's just to...
  9. Kevins Gtv

    p3 jts lusso
  10. Alfa GTV & 916 Spider
    The idle on my Spider 2.0 T.Spark starts when cold at 1800rpm and when fully hot fluctuates between 2200 and 2800. I have removed and checked the rubber ducting for leaks, replaced the air filter and rmoved and cleaned the throttle valve assembly. I also removed the stepper motor and attempted...
  11. Alfa 147, 156 & GT
    I heard you need special software to reset the stepper motor! Does that mean dealers only? I have Alfa diag but will that be ok! If so do I need to remove the Stepper motor from thottle body in order to reset it?
  12. Alfa GTV & 916 Spider
    Still on my quest for smoother running!.... I removed the idle stepper motor, and did not pay enough attention whilst doing it. I know, I know...:tut: Does anyone on her know which side of the spring arm in the this picture the tang that sticks out of the throttle body needs to go? Should the...
  13. Alfa 164 & 166
    Now that it's turned cold I thought about turning the temp up but the air con felt otherwise and it remained freezing cold! Not only that but I also had to contend with the characteristic clicking from the stepper motor if I selected anything but Lo. I found out from my mechanic that the best...
  14. Alfa GTV & 916 Spider
    Just wondering, if my idle control valve is acting up, would it affect starting? My car turns over lots before it starts and I usually need to put my foot on the accelerator before it starts. When it does start, the idle usually takes a while to catch, when it does it seems to idle fine. Every...
  15. Alfa 145 & 146
    Hi everyone, I'm looking for a stepper motor for an X reg 146ti cloverleaf, if anyone has or knows of one for sale on the cheap I'd be grateful to hear about it as I think I need a new one... many thanks in advance, Ramsay
  16. Alfa 164 & 166
    Hello Again I'm sorry I loaned out my laptop and now I have no ePer again. :rolleyes: Can anyone please tell me from ePer the AR part number for the stepper motor from a 1994 164 thank you. They're all the same for any 164 of that year. From memory, it's in: 164/W2 164 super...
  17. Alfa 145 & 146
    Hi all, since I've had my car (nearly a year now) I have always had a dodgy idle and occasional running problems. Had the cambelts done and throttle body cleaned and went like a rocket after that, but just had a high idle on start up (about 2k rpm) and still is high now. Recently I have bought a...
  18. Alfa GTV & 916 Spider
    :confused: My 2.0 T.S Spider idles at 800 most of the time but goes from 800 to 1500 at lights/waiting and sometimes takes time for the revs to drop, Ive been told its my STEPPER MOTOR. My son has a pug 306 Gti 6 and changed his, could he change mine without having to do something with (or...
  19. Alfa 164 & 166
    Well, summer's here, and so is the heat. My Super has decided to vent hot air in my face for no apparent reason.... or so I thought. Had a look under the plastic cover between false firewall and windscreen base. It appears the plastic crank attached to the cable from the stepper motor (which...
  20. Alfa 145 & 146
    Where can i buy a stepper motor from
1-20 of 24 Results