Alfa Romeo Forum banner

seal

  1. Alfa 147, 156 & GT
    Today's little job was to replace the long roof seal that goes from the top of the front wing back along the roof to the rear door handle. Amazingly you can still get these and it's quite a nice easy job compared to other seals on the 156. So for those interested or thinking of doing this job...
  2. Alfa 147, 156 & GT
    Hello dear alfistis, I'm new to this forum. Hope you are able to help. The rubber that seals the back of the right headlight is worned out, and when it rains water enters from the cracks. You can see this in the pics in appendix. Do you now each is the type of rubber to replace the old one...
  3. Alfa 147, 156 & GT
    Hi all, I changed the condenser on my GT 2-3 months ago to an NRF make. https://www.nrf.eu/products/condensers/ Review is good and the price was competitive (mid range). The replacement was smooth, although slight persuation was necessary to align the mounting points with the car but it was...
  4. Alfa 159, Brera & 946 Spider
    Hi Ladies and Gents, I have done a search but not got the answer so I thought I would turn to your collective genius. I need the part number for the seal that sits against the rear upright side of my drivers door glass on my Spider 939. It clips into the roof and mine has split and I need to...
  5. Alfa 159, Brera & 946 Spider
    Need some advise ..recently I have changed clutch kit on my Bella...however, my mechanic noticed the flywheel oil seal leaked and replaced it but after 2 days, it shows leaks again...the second time he replaced it , it leaks again...could it be have to replace it with original oil seal as...
  6. Alfa 147, 156 & GT
    Hi all... I have a 2010 Alfa Romeo GT, which had the unfortunate luck to have a windscreen replaced with its previous owner. I noticed when I'm driving with 140km/h there's a bit of wind noise, so I started an investigation. No leaks or air coming through, but I did notice there's a seal...
  7. Alfa GTV & 916 Spider
    There's plenty of these kits available online, but I cannot find one for the Spider. It has a Bosch/Bendix 0 204 123 623 unit shown below, despite Autofren telling me my model must have a *** cylinder. Can anyone point me towards a source for either a repair kit or just the three main seals?
  8. Alfa Giulia
    Giulia Super Veloce has done 85000 kms. Very well looked after, detailed every month, love it. But.... have noticed excess wear & tear on drivers side door seal. Was suggested by Alfa service centre that it is due to positioning of pillar and the constant rubbing as driver exits the vehicle. I...
  9. Alfa 159, Brera & 946 Spider
    Hi All has anyone replaced the driveshaft oil seals on the M32? Once the shaft is removed and the gear oil drained do the old ones simply hook out and the new ones press/tap in? The seal on the right hand/long driveshaft is weeping oil where it enters the diff. and needs to be pulled and replaced.
  10. Alfa GTV & 916 Spider
    I’m currently sorting out the various parts of a Cup kit ready to fit on my GTV that I’ve acquired over the years. The previous owner of the front splitter as well as having a liking for hitting curbs with it seems to have had some sort of fetish for tiger seal or some other similar adhesive...
  11. Alfa GTV & 916 Spider
    Ph1 2.0. Failed the mot on emissions and all readings pointed to the cat, bought a new one. Removed the old one, gasket at either end, cleaned up the surfaces and popped down the motor factors and bought 2 new gaskets. Little smear of paste then bolted everything up, started the engine and it’s...
  12. Alfa Giulia
    I have the seat all the way back in my Giulia and find the B pillar is somewhat in the way when getting in and out, today I noticed that I have worn right through the door seal rubbing past it. It seems to me that the material is particularly soft as I have also torn it at the base of the door...
  13. Alfa 147, 156 & GT
    I noticed damage on my intermediate shaft oil seal. I wondered if anyone knew if this was the same as the driveshaft seal or what the part code might be? 147 JTDm 150, 2006
  14. Alfa GTV & 916 Spider
    Hi all, finally got my spider back from paint so time to put it all back together and get it on the road. A few of the window seal clips have broken though so was wondering if anyone knows where I can get them? I've attached a photo but they're the ones on the top of the door inside the window..
  15. Alfa 147, 156 & GT
    Hi all I’m in the process of sorting out all the cosmetic issues on my fantastic 156 2.5 V6 Sportwagon (2005). One of the worst parts of the car are the door and boot seals - some are in a bad shape and I want to replace them. Has anyone done this with the 3rd party seals you would find on...
  16. Alfa 159, Brera & 946 Spider
    Hi guys....im looking for the front left drive shaft seals....its pouring oil out...i could find much info on it....ive got a few diagrams....but dont know its it right or not....any help would be much appreciated....thanks
  17. Alfa 159, Brera & 946 Spider
    Right, next issue to solve! I have water coming in right above the drivers window, it’s where the seal I think is split to allow the roof to fold up at the hinges? If I look up at around 10/11 o’clock driverside window, I can see daylight/small gap, the seal in this area seems to be in separate...
  18. Alfa 147, 156 & GT
    Found these in the back of the garage. I remember buying these separately then having to buy a kit to get some of the others I needed when I changed the head gasket on the 156. Cam cover seal £12.50 Inlet manifold gasket £7.50 (See attached pic for type) plus postage costs
  19. Alfa 147, 156 & GT
    Hi I am hoping for help as my local dealer is stuck with a problem with my left hand side transmission seal. The housing part number is 46475232 and according to the Alfa dealership and my own research the correct seal should be part number 40004430 which has the dimensions of 32 x 52 x 10/13.5...
  20. Alfa 147, 156 & GT
    I would like to change the door/window waist seals on all four doors on my 156 SW. Does anyone here happen to know if it’s possible to get new ones or if I will have to start looking for used ones?
Top