Alfa Romeo Forum banner

removing

  1. Removing gear selector cable

    Alfa 147, 156 & GT
    Hi all, I'm trying to replace the bushes in the gear selector on the other half's 147 as reverse and third are very stiff occasionally, and the gear stick is sloppy. I'm following the Alfa Workshop guide here: https://www.alfaworkshop.co.uk/Alfa_147_GT_156_Gear_selector_plate_removal.shtml But...
  2. Help required: removing air vents

    Alfa MiTo
    Evening all, A quick search on the forum yielded no results, so here we go: how does one remove the 4 air vents from the dashboard? Specifically, the 4 round front-facing ones. If I recall from the 159, it takes two J-shaped pieces of wire/metal and a firm tug to pull them free. Is it the same...
  3. Removing underseal

    General Motoring Discussion
    I'm currently cleaning up the under-floor of the Younger Mrs S's Cinquecento since it failed an MOT with some rusty chassis rails (now welded up). While I'm there (subframe out, fuel-tank out, brake lines out etc.) I decided it might be a good idea to repaint the whole underfloor and wheel...
  4. Removing aircon condenser ...

    Alfa 147, 156 & GT
    Just a quick check with you guys about this - maybe save sometime from having to take bumper off and reinstall a failed item. I stripped out my radiator and condenser when I had to replace the leaking radiator. Condenser was a mushy mess and clearly not functioning, so I didn’t reinstall or...
  5. Guide on removing centre console to replace radios (automatic)

    Alfa 159, Brera & 946 Spider
    Hi all new to the form looking for some help as above I’m hoping for a guide or some help on how to replace the radio for a double din I assume I need to remove the centre console and the trim around but the gear selector my car is a automatic so it’s a bit different than a Manuel when it...
  6. 156 JTS Camshaft position sensor change without removing exhaust sprocket

    Alfa 147, 156 & GT
    Hi all, I just spent 46 minutes typing out a new thread on this, whilst logged in but I lost the post because I think I got logged out within that time :/ long story short: someone posted a guide on a couple of forums on how you can replace the camshaft sensor on a 156 JTS without removing the...
  7. Removing Cold Start from Giulia 2.0L Petrol

    Alfa Giulia
    Has anyone done this? Think some tuners can remove the function of pumping heat into Cat upon startup until warm. Have an aftermarket exhaust and happy with sound except on cold start when it sounds too much. Have you heard of any alfa tuners who have done this on Giulia or other models? Is...
  8. Removing 8v Heat exchanger

    Alfa 147, 156 & GT
    There used to be a large nut inside the heat exchanger behind the filter thread on petrol models . I want to be able to remove a exchanger on an 8v Diesal Multijet as one of the pipes have cracked so that I can braze it. I can only see a plane circle on the inner central thread , I presume this...
  9. Removing air box

    Alfa GTV & 916 Spider
    Hi I’m planning to remove the air box next weekend. To remove the bottom pipe do I need to remove the plastic undertray or the wheel arch liner? Thanks Ian
  10. Removing ignition barrel

    Alfa 147, 156 & GT
    I need to remove the ignition barrel from the steering column - what's the best way to deal with the two cone-shape headed bolts? Not a lot of space to get a drill in there. Sent from my LYA-L29 using Tapatalk
  11. removing the CODE box causes bouncing locks?

    Alfa 164 & 166
    when i installed the reprogrammed ECU into my 3.0 fl, I reasoned that since the ecu no longer needs a CODA function, I could take the code box out of the circuit. Having done this I now have bouncing locks. Is it a coincidence ? and i need to strip and clean the locks? or should I re plug the...
  12. Help! Removing interior heater fan resistor

    Alfa GTV & 916 Spider
    Hey all, I've been meaning to remove my interior fan resistor for a while as my fans got stuck on full blast before Xmas even with the engine off. Finally got around to doing it over Easter, managed to get it out after reading other topics on the subject. But I cannot seem to get the...
  13. Removing Adaptive Cruise Control

    Alfa Giulia
    I dislike the adaptive cruise control and wonder if other people feel the same. My dislikes: When cruising on the motorway the range is too long even when set to " 1 bar" meaning that the car slows down causing me to have to accelerate before I pull out into the overtaking lane. If I pull...
  14. Removing fuel tank on 147

    Alfa 147, 156 & GT
    I have a fuel leak from my tank. I think its a hose loose at the top of the thank as it only comes out when I top it up. Its been like this since I bought the car and I never worried about it but I was thinking that I should have a look at it. How do I remove the tank? It looks like I have to...
  15. Removing clutch actuator arm. Help!

    Alfa 147, 156 & GT
    I've a 147 Ducati and I'm trying to remove the clutch actuator arm so that I can try and lubricate the bushes on the shaft as my clutch feels awful after about 20/30 mins (but does this sporadically), but it's well seized on to the splines. This is the 2nd time I've tried and it's still...
  16. removing inlet plenum

    Alfa GTV & 916 Spider
    Done this today since I see no total guide (unless im blind) lol thought I put some pictures up today to show where the bolts are :) This is on a 3.0 v6 24v cf3 engine too. You may not have to remove number 1 as there is another one under where the black box sits with all the wired connections...
  17. Removing ac compressor

    Alfa GTA
    Has anyone removed the ac from there GTA and If so is there a shorter ancillary belt. Thanks Sent from my iPhone using Tapatalk
  18. V6 Engine Bushing - removing metal sleeve

    Engines (TS, JTS, JTD & V6)
    Guys, Has anyone got any tips for removing the inner metal sleeve on the upper engine mount bushings, I’ve taken the part out and removed the bushing but I cannot get the metal sleeve out...I’m working within a Vice for getting a good grip on it is an issue...I’ve tried cutting it and chiseling...
  19. removing giulietta rear light cluster

    Alfa Giulietta
    I tried to change an indicator bulb on my Giulietta and there is on bolt to remove. The handbook says remove this and pull the light cluster in the direction shown,which is pulling towards you.Nothing happens,I looked on here and somebody had posted get a soft plastic spatular (the type you cook...
  20. GT window removing fuse fix ? Or not !!

    Alfa 147, 156 & GT
    Guys, my passenger window is acting up , keeps dropping and raising all on its own then it stays in the fully open position !! Is it possible for me to get the window back up and before it drops back down , if I remove the fuse (I'm assuming there is one for the windows) will that hold the...
Top