I have a 2008 2.2jts Spider 58k FDSH, couple of days ago whilst sat in traffic, the engine gave a bit of a cough and the Check engine warning message came on followed by the engine light. Didn't go into to limp mode. Drove to destination ( a couple of miles) switched it off, back on...
Morning fellow Alfisti
What ODB2 readers are you guys using? I know you can probably get the Fiat software by scouring the net, but I’m massively paranoid about malware (nothing is free, right?)
Seen a few readers listed on eBay ranging from £20-90
Any good? Or better still, any...
Very frustrated Alfa owner here. I had just sold a 2008 Alfa 147 JTDm yesterday and luck would have it that the guy who bought it had a "motor control system failure" light pop up.
I called my local Alfa specialist in Launceston who gave me two bad pieces of news:
1) The car is...
I've had a good scan through the forum but can't find a thread on the problem I'm currently experiencing with my 2008 159SW - apologies if I've missed it...
two weeks ago, with no warning, the engine cut out at a junction after driving for about 2 minutes. Odd... I restarted, and carried on...
Hi guys, after replacing my egr cooler the guilietta a week later has now gone into limp mode, I am assuming something todo with the egr cooler change however really need a good code reader. I’m not very good with computers so looking for a plug in and play one....... loads on ebay! Anyone got...
I've noticed that TEG reader might be root of recent electrical problems with my car.
Overall it seems to shut CAN down communication intermittently thus causes various errors and I suspect it because it seems governing main supply of power to the car. One of the main symptom is that it would...
Has anyone actually used with success any of the Chinese code readers such as this:
and many others.
Any insight is appreciated.
Looking for the above,
Been getting intermittent EWL flashes, be good to diagnose these things myself in case I need to visit garage.
The kind of thing you don't use often, so whilst not looking to spend a packet on one be good if it was known to be reliable etc.
Any recommendations please...
I was looking for clues as to why the cruise control was not working on my -06 1.9 jts 159 when the following happened:
Right after succesfully connecting an obd reader and firing up the ignition, starting the reading process, all possible fault lights and counters began blinking or light up...
Anybody found an OBD reader that works on a Brera. I used an Aute* which has twice corrupted my canbus system. Its cost me £160 to sort out and put the car back to normal. Suggestions would be appreciated providing you have used it in anger.
I thought I would upgrade my OBD2 reader to a better unit - Konnwei KW808
However, on connecting it I just keep getting "Vehicle Linking Error'
I followed the instructions but still no joy - Has anyone else tried this unit or happen to have one that does actually work?
It states that it's...
After purchasing three OBD bluetooth readers from Fleebay and
the last one a link on hear which the member had success with all failed for me.
It does seem the cheap ones are very much so hit and miss.
So I bit the bullet and raised the budget and for twenty squid purchased a Panlong wifi reader...
I'm wondering if anyone has any experience with the device in the title of this thread, or at least might be able to advise me on reading the fault codes and interpreting their clues to resolving my rough running problem. I changed all three belts last week. Other than the water pump the change...
Can anyone provide a link to an OBD Bluetooth Reader suitable for my 2008 Brera?
To be used with Torque Pro on an Android phone.
The search I did were old and the listings had long since expired.