Alfa Romeo Forum banner
powerflexed
1-13 of 13 Results
  1. Alfa GTV & 916 Spider
    Following the installation of polybushes in the upper engine mount, today i went for a short walk, to see differences, confirm that everything was ok etc... Well, NOT everything was ok... After a short spin (just a 0-100), Lower polybush, went off! Just that... Thank god, it didnt dropped on...
  2. Alfa 159, Brera & Spider
    Anyone fancy a pair of upper wishbones with the power flex adjustable bushings? The ball joint has no excess play, in fact the wishbones have done very few miles, I just took them off because of the creaking. They'll need a good clean and grease and you'll need to be able to set them up...
  3. Alfa GTV & 916 Spider
    I've listed it in classifieds if anyone is interested. I cannot justify 3 cars, and although it's a fabulous drive the V6 still pips it. Has loads of history including 2 cambelt changes the last one being about 3 years ago with little mileage since. Open to sensible offers.
  4. Alfa 159, Brera & Spider
    I bought this Brera at the end of December and I've been gradually making this two-previous-owners car mine. New battery, new rear drop link, clutch switch, fixed the cruise control, added larger rims and new tyres, even though the old tyres still had plenty of life on them. After reading the...
  5. Alfa GTV & 916 Spider
    As new only fitted to car for 4 months. £450
  6. Alfa GTV & 916 Spider
    Have just had this put on my car http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=230940041550 along with new rear drop links theres was a small crack in the subframe which was welded. got it back last night and it handles a lot better but there is still a knock and sqeek when going over...
  7. Alfa GTA
    Whilst the GTA is in I'm having the rear hub bushes (thanks azraphale) and some new upper wishbones put in with specially developed non squeaking bushes. Apparently this has been an issue in the past when powerflexing upper arms but Ned had a word with the guys at powerflex who then came up with...
  8. Alfa GTV & 916 Spider
    CHECK THESE OUT http://www.ebay.co.uk/itm/260887462653?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
  9. Alfa 164 & 166
    I've got to have this done in the next couple of weeks to get the car through the mot. I'm after peoples experiences not of fitting but just of the finished result. I'm having the merc knuckle done as well so anyone that's had both done their experiences would be gratefully appreciated.
  10. General Alfa Discussion
    I had Powerflex bushes fitted today on the rear of my GTV .......... Did the lot. A couple of the existing rose Joints were shot, although there was no visible play while they were on the car but it became apparent when the suspension was dismantled ........... .......... anyway, took it for a...
  11. Alfa GTV & 916 Spider
    At my next service I'm going to need new spring pan arms, or I'll just get the whole rear Powerflexed, and in the current climate I'm leaning towards PF as it's cheaper than OE parts and lasts longer. So, can I ask for recommendations for places where you guys have had this done and for the...
  12. Alfa GTV & 916 Spider
    Hi Guys, Just powerflexed the rear spring pan arms on my gtv. Was a nightmare getting everything to fit back on and am sad to say but I could only put 1 of the washers over the tophat bushes on each side. There was no way it was going back in with both washers in place. Has anyone else had this...
  13. General Alfa Discussion
    Just thought I`d share this with you,for any of you contemplating changing bushes and wanting to uprate but without the hassle of trying to faff around with removal/fixing of bushes.Basically they supply a complete arm pre-fitted with the powerflex urethane bushes. This is the route my...
1-13 of 13 Results
Top